Outputs - Classe Audio CP-50 Owner's Manual

OUTPUTS

The CP-50 has both regular (single-ended) and balanced outputs. Both are working at all
times, and may be used separately, or simultaneously.
TAPE OUTPUT
Whichever input is selected will be fed to the TAPE OUTPUT jacks. This should be
connected to the TAPE IN or LINE IN of the tape deck.
REGULAR OUTPUTS
Simply connect your regular interconnects to the RCA output jacks marked REGULAR OUT
on the back of the CP-50.
BALANCED OUTPUTS
A balanced power amplifier and balanced interconnects are also required. For use with
balanced power amplifiers other than Classé, the wiring of the 3-pin XLR connectors must be wired
as follows:
If the pin configuration of the power amplifier differs from above, the balanced interconnects
must be modified to accommodate the different power amp.
Having confirmed the correct connections, plug the XLR connectors of the balanced
interconnects into the locking XLR connectors on the rear panel of the CP-50 marked BALANCED
OUT. (To remove the connectors, press the tab above the connector.)
PIN 1: GROUND
PIN 2: POSITIVE (NON-INVERTED) SIGNAL
PIN 3: NEGATIVE (INVERTED) SIGNAL
-8-