4. Use ↑ or ↓ to select CLO
5. Press → to pull down the menu
6. Use ↑ or ↓ to select Target
7. Press → to pull down the menu
8. Use ↑ or ↓ to select Normal Mode ...
Image 7-111
9. Press ENTER
A dialog box is displayed
Image 7-112
10.Use ←or →, the numeric keys on the remote, or the keypad to change the target value.
7.7.4.3
Linked CLO
Introduction
Projectors in a multichannel setup use the same kind of lamp. These lamps may slightly differ in their output and will in certain cases
have different runtimes, this will result in a difference in light output between the projectors.
By using the constant light output in a Master/Slave configuration, it is possible to track and maintain the brightness levels of the
projectors, the projectors will deliver an equal light output.
In a multichannel setup (max. 10 projectors ) it is possible to link the CLO values of all projectors. One projector will act as master,
all slave projectors will track and maintain the CLO setting of this master projector.
Following CLO Settings are available:
MASTER
SLAVE
OFF
Table 7-6
CLO Settings
The linked projectors must be defined by their IP addresses or Hostnames. This is done in the Linked projec-
tors menu in the Installation menu.
R59770121 NH-12 04/05/2011
Master projector to control the CLO in a chain of projectors, the target value in the Master projector will be
the target value for all projectors set as slave and which are listed in "Linked Projectors"
Follows the master projector to adjust the CLO
no linking ( note : if CLO mode is ON, it will applied on the projector itself)
7. Advanced
111