Setting Up The Projector Address (Only If Necessary); Setting Up The Orientation - Barco NH-12 User Manual

5.4

Setting up the projector address (only if necessary)

What can be done ?
The projector is shipped with projector address set to "0"
In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-
pendently).
In the OSD menu Projector Address, the following addresses can be programmed :
• Projector address: address defined by the user, may be from 0 to 255
0-9 is used for RCU communication, 0–255 being used for RS232 serial communication.
• Common address : address may be 0 or 1
How to change the projector's address ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Projector address
Image 5-9
5. Press ENTER
A dialog box appears on the screen
Image 5-10
6. Enter the new projector address with the digit keys on the RCU, the local keypad or the cursor keys.
How to change the common address ?
1. Proceed in the same way as for the projector address
5.5

Setting up the orientation

What must be done ?
Depending on the mechanical orientation of the projector, the projector's internal settings have to be adapted.
R59770121 NH-12 04/05/2011
5. Setup
41