Starting Up The Projector - Barco NH-12 User Manual

5. Setup
In normal conditions, the network detection takes about 25 seconds. This means that the total time needed to
go from power ON to Standby mode can take up to 85 seconds. This value can vary depending on the speed
of the network connection.
If the network cable is plugged in, but no real network is connected to it, this start-up time can take up to 120
seconds: 60 seconds where the backlight of the LCD display is ON but no message is displayed, increased
by 60 seconds during which the LCD display shows the text BOOT.
NH-12
Image 5-3
Standby status
The standby status is shown on the LCD display. An information field will rotate between the following information strings :
• Projector name
• Hostname : this is the name defined in the network settings menu, see Network settings
• IP address
• Baudrate
• RCU private address
• RCU common address
NH-12
Common 0
Private 1
Image 5-4
Standby status
5.2

Starting up the projector

How to start up the projector ?
1. Press the Standby button on the RCU or on the local keypad
38
standby
NH-12
Hostname
150.158.193.179
57600
Boot
R59770121 NH-12 04/05/2011