Barco NH-12 User Manual page 126

7. Advanced
Red L
Green L
Blue L
White L
Desired Values
Red x, y
Green x, y
Blue x, y
Cyan x, y
Yellow x, y
Magenta x, y
White x, y
Red L
Red Lmax
Green L
Green Lmax
Blue L
Blue Lmax
Cyan L
Cyan Lmax
Yellow L
Yellow Lmax
Magenta L
Magenta Lmax
White L
White Lmax
Factory Preset
Calibration
Default Desired
122
Red Light output
Green Light output
Blue Light output
White Light Output = Red + Blue + Green Light output
These are the colors you want the projector to display when the status is enabled
Coördinates for the Red point
Coördinates for the Green point
Coördinates for the Blue point
Coördinates for the Cyan point
Coördinates for the Yellow point
Coördinates for the Magenta point
Coördinates for the White point
Red Light Output
Maximum available Red Light Output
Green Light Output
Maximum available Green Light Output
Blue Light Output
Maximum available Blue Light Output
Cyan Light Output
Maximum available Cyan Light Output
Yellow Light Output
Maximum available Yellow Light Output
Magenta Light Output
Maximum available Magenta Light Output
White Light Output
Maximum available White Light Output
Sets the measured parameters back to the factory preset for the current set
This starts the calibration procedure for the measured points of the current set (Changing these
settings may seriously affect the performance of the projector).
This will reset the desired parameters to no color change values (measured values). This can be
interesting to recalculate the secondary colors.
R59770121 NH-12 04/05/2011