The Soft Edge Edit Wizard; The Soft Edge Edit Modes - Barco NH-12 User Manual

7. Advanced
7.9.7.4.1

The soft edge edit wizard

The geometry wizard
When entering the Edit mode, the Edit dialog box is displayed.
Description of the Edit dialog box
An intuitive user interface is used to perform all the Soft edge adjustments.
Image 7-146
Field Description
/adjustment
Planes
Allows to select the type of soft edges :
- internal soft edge
- Alpha-Beta planes
Edges
It is possible to select one or more of the 4 edges of the
image:
Left/Top/Right/Bottom
Source The background image on which the soft edge adjustment
is applied can be the source or a full white image (pattern)
Adjustment guide An adjustment guide consisting of a 4 brightness graduated
bars can be applied on the background image during the
soft edge adjustment
Hierarchy level Allows to select the level of the adjustment.
Reset
The soft edge shape is set to default settings.
Table 7-10
dialog box legend
7.9.7.4.2

The soft edge edit modes

The Edit Modes
• Select mode : allows to select the desired point using the ←and→ arrows or to select the desired level or edge using the ↓and
↑ arrows.
• Adjust mode : allows to perform the correction (in real time) using the arrows.
• Edit mode : allows to select the desired control (edit box, ...) in the dialog box.
• Change mode : allows to change the values in the edit boxes of the dialog box.
134
Notes
A Disabled edge is a hard edge. Adjusting a
hard edge results in a blanking adjustment.
See blanking
The procedures in this manual are explained
using a full white background
Soft edge shape follows geometry settings,
the shape of the soft edge is set to 12.5%,
enabled edges stay enabled, disabled edges
stay disabled
R59770121 NH-12 04/05/2011