Linked Clo; General - Barco Sim 5H Owner's Manual

Image 7-115
The Dimmer dialog box will be displayed.
Image 7-116
7. Use the cursor key ← or → , the numeric keys on the RCU, or the local keypad, to set the dimmer to the desired value.
8. Press ENTER to activate the new dimmer setting.
9. Press BACK to return to the Lamp menu.
7.5.4.4

Linked CLO

Introduction
Projectors in a multichannel setup use the same lamp. These lamps may slightly differ in their output and will in certain cases have
different runtimes, this will result in a difference in light output between the projectors.
By using the constant light output in a Master/Slave configuration, it is possible to track and maintain the brightness levels of the
projectors, the projectors will deliver an equal light output.
In a multichannel setup (max. 10 projectors ) it is possible to link the CLO values of all projectors. One projector will act as master,
all slave projectors will track and maintain the CLO setting of this master projector.
Following CLO Settings are available:
MASTER
SLAVE
OFF
Table 7-5
CLO Settings
The linked projectors must be defined by their IP addresses or Hostnames. This is done in the Linked projec-
tors menu in the Installation menu.
7.6

General

Overview
• Identification
• Pause
• Freeze
• Standby Timer
• Desktop
R59770247 SIM 5H 04/06/2008
Master projector to control the CLO in a chain of projectors, the target value in the Master projector will be
the target value for all projectors set as slave and which are listed in "Linked Projectors"
Follows the master projector to adjust the CLO
no linking ( note : if CLO mode is ON, it will applied on the projector itself)
7. Advanced
103