Steps To Removing The Camera Base For Installation; Steps To Install The Base Cover - FLIR D--Series Installation And Operation Manual

4.2. Steps to removing the camera base for installation

1. Hold the camera upside down firmly. You may need someone else to hold the camera
housing at this point to keep it from turning.
2. Pull the tab out, being careful not to break it, while at the same time pushing down on
the base. Do not use a screwdriver or any other metal tool to pull the tab out or you may
break it.
1. Pull tab out
and hold
3. While pushing the base down and holding the tab out, rotate the base clockwise. This
will release the locking mechanism and you can now pull out the base cover.

4.3. Steps to install the base cover

1. To install the base, align the cutout on the base with the pull out tab
444-00001-00-10 Revision 110 Copyright © 2008 FLIR Systems, Inc.
2 and 3: Push
down and turn
base counter
clockwise
Page 19 of 33