FLIR D--Series Installation And Operation Manual page 13

ceiling ("pendant" installation), in which case the entire camera body (minus the housing
enclosure mount) hang from the ceiling in plain view. Which mounting type you use depends on
your specific security needs.
When cutting the hole for the camera in the ceiling, be sure to follow the template provided
carefully. If the hole is cut too large or imprecisely, the camera will not fit snugly in the hole and
it will be difficult to secure the camera safely.
NOTE: It may be useful to have another person hold the camera in place while tightening the
spring clips.
Cut an approximately 9 ½ " diameter hole in the surface where the dome is to be
Step 1
mounted using the template provided with the SR-Series camera. A sketch (not to
scale) is shown in Figure 5.
444-00001-00-10 Revision 110 Copyright © 2008 FLIR Systems, Inc.
Cutouts
Page 13 of 33