FLIR D--Series Installation And Operation Manual page 18

Catch
When you lift the inner cylinder, the bottom of the cylinder, which contains the
Step 4
electronic interface board, remains attached to the dome bottom. The ribbon
cable and safety cable connect the two parts.
Ribbon cable
Cylinder bottom
NOTE: To make it easier, you may want to disconnect the cables and completely remove the
inner cylinder. The cylinder bottom is attached to the dome by four screws on the bottom of
the dome. You may remove it as well. A safety cable attaches the cylinder to the cylinder
bottom and is designed to keep the cylinder from falling off if the maintenance person were to
accidentally drop it.
444-00001-00-10 Revision 110 Copyright © 2008 FLIR Systems, Inc.
Safety cable
Page 18 of 33