Condensate Trap Tubing (Factory-Shipped Orientation); Condensate Trap Location (Alternate Upflow Orientation) - Carrier 58MVP Installation, Start-Up, And Operating Instructions Manual

PLUG
CAP
COLLECTOR
DRAIN TUBE (BLUE
& WHITE STRIPED)
COLLECTOR
TUBE (PINK)
DRAIN TUBE (BLUE
& WHITE STRIPED)
COLLECTOR BOX
TUBE (PINK)
©
(MOLDED) DRAIN
TUBE (BEHIND
COLLECTOR BOX
DRAIN TUBE)
DRAIN TUBE (BLUE)
COLLECTOR BOX
TUBE (GREEN)
FACTORY-SUPPLIED
DRAIN TUBE
COUPLING (LEFT
DRAIN OPTION)
FIELD-INSTALLED
FACTORY-SUPPLIED
DRAIN TUBE
FIELD-INSTALLED
FACTORY-SUPPLIED
//2 -IN CPVC STREET
ELBOWS (2) FOR
LEFT DRAIN OPTION
FIELD-INSTALLEE
FACTORY-SUPPLIED
DRAIN TUBE
COUPLING (RIGHT
DRAIN OPTION)
A94213
Fig. 7--Factory-SNpped Upflow Tube Configuration
(Shown With Blower Access Panel Removed}
(ONDENSATE TRAP TLTBING (FACTORY_SHIPPED
ORIENTATION)
NOTE: See Fig 7 or tube routing label on main furnace door to
confirm location of these tubes
1. Collector Box Drain, Inducer Honsing Drain_ Relief Port, and
Pressure Switch Tubes
These tubes should be factory attached to condensate trap and
pressure switch ready for use in UPFLOW applications. These
robes can be identified by their connection location and also
by a color label on each tube. These tubes are identified as
follows: collector box &ain tube (blue label), inducer housing
&ain robe (violet label or molded), relief port robe (green
label), and pressure switch robe (pink label).
2. Condensate Trap Drain Tube
The condensate trap drain connection must be extended for
field attachment by doing the fbllowing:
a. Detem_ine location of field drain connection. (See Fig. 2 or
7.)
NOTE: If internal filter or side filter media cabinet is used., &ain
robe should be located to opposite side of casing flora return duct
attachment to assist in filter removal
b. Remove and discard casing drain hole plug button from
desired side.
COLLECTOR BOX
TUBE (GREEN)
COLLECTOR BOX
DRAIN TUBE (GREEN)
TRAP
HOUSING
DRAIN TUBE
(VIOLET)
O O
A94214
Fig. 8--Alternate Upflow Tube Configuration and
Trap Location
c Install drain tube coupling grommet (fScto_--supplied in
loose parts bag) in selected casing hole.
d. Slide &ain robe coupling (fi_ctoryosupplied in loose parts
bag) through grommet so long end of coupling fitces
blower.
e Cement 2 factolw-supplied 1/2-in. street (PVC elbows to
rigid drain tube connection on condensate trap. (See Fig. 7.)
These elbows must be cemented together and cemented to
condensate trap drain connection.
NOTE: Failure to use CPVC elbows may allow drain to kink,
preventing draining.
f\ (onnect larger diameter drain robe and clamp (factor-
supplied in loose parts bag) to condensate trap and clamp
securely.
g. Route robe to coupling and cut to appropriate length.
h. Attach robe to coupling and clamp securely.
COND]_NSATE TRAP LOCATION (ALTERNATE UPFLOW
ORIENTATION)
An alternate location for the condensate trap is the leR_hand side
of casing. (See Fig. 2 and 8.)