Dimensional Drawing - Carrier 58MVP Installation, Start-Up, And Operating Instructions Manual

SiDE iNLET
27
CONDENSATE
DRAIN LOCATION
(U PFLO\A/}
O
AIRFLOW
TYP
OUTLET
A m
CONDENSATE DRAIN
TRAP LOCATION _
(DOWNFLOW &
HORIZONTAL RIGHT)
OR ALTERNATE
, 1biN DiA GAS CONN
30 i_,,
1
18 _,_
i
INLE_ DRA{N LOCATION
DIMPLE LOCATORS
FOR HORIZON 17_,L
HANGING
7m-IN DIA
POWER CONN
I _z-IN DIA
THERMOSTAT ENTRY
)NN
I SiDE INLET
I
I
I
NOTES:
1. Minimum return-air openings at furnace, based on metal duct. If flex duct is used,
see flex duct manufacturer's recommendations for equivalent diameters.
2. Minimum return-air opening at furnace:
a, For 800 CFM-16qn, round or 14V_x 12in, rectangle.
b. For 1200 CFM-20qn. round or 14V, x 19V2qn.rectangle.
c. For 1600 CFM-22-in. round or !4_/_x 23V,-in. rectangle.
d. For airflow requirements above 1800 CFM, see Air Delivery table in Product Data
literature for specific use of single side inlets. The use of both side inlets, a
combination of 1 side and the bottom, or the bottom only will ensure adequate
return air openings for airflow requirements above 1800 CFM.
Dimensions (in.)
UNIT SBZE A D E
040-14* 24-1/2" 22-7/8" 23*
060-14 17-1/2 15-7/8 16
080-14 21 19_3/8 19-1/2
080-20 21 19_3/8 19-1/2
100=20 21 19_3/8 19-1/2
120=20 24-1/2 22-7/8 23
* These dimensions reflect the wider casing for the Trophy (96,6 percent AFUE) furnace
Fig. 2--Dimensional Drawing
A99111