Vq Link Plate; Using The Vq Mb For Additional Pattern Control - Tannoy VQ 60 User Manual

7.3 VQ LINK PLATE

The VQ link plate is used to join a VQ DF or VQ MB to a VQ 60 or VQ 100 cabinet. Three link plates are used to
connect each cabinet. The Link plates are supplied as standard with each VQ DF and VQ MB.
Remove the M10 countersunk screws as shown in the diagram opposite. Use the same screws to fix the link plate
in place. The link plate will sit flush in the cabinet indentations. Two longer M10 bolts are supplied with the link
plates. These bolts should be used to fix the rear link plate in position.
Note: All fixings should be thread-locked and torqued to 25Nm
LINK PLATE

7.4 USING THE VQ MB FOR ADDITIONAL PATTERN CONTROL

The VQ link plate is used to join a VQ DF or VQ MB to a VQ 60 or VQ 100 cabinet. Three link plates are used to
connect each cabinet. The Link plates are supplied as standard with each VQ DF and VQ MB.
Remove the M10 countersunk screws as shown in the diagram opposite. Use the same screws to fix the link plate
in place. The link plate will sit flush in the cabinet indentations. Two longer M10 bolts are supplied with the link
plates. These bolts should be used to fix the rear link plate in position.
20