Coordinate System - Standard Horizon HX851 Owner's Manual

7. To exit this menu and return to radio operation mode press the [ 16/9 ] key
or press the [ CLR ( WX )] key several times.
When Navigation or the GPS Status page is selected in the Radio Setup
menu (refer to section "8.1 DISPLAY"), the GPS receiver will be auto-
matically set to Level 1.

10.3 COORDINATE SYSTEM

This selection selects the Coordinate System to be shown on the HX851 dis-
play. The default setting is "ddd mm.mmm".
1. Press and hold the [ CALL ( ENT ) MENU ] key until "Setup Menu" appears.
2. Press the [ ] key to select "GPS Setup" menu.
3. Press the [ CALL ( ENT ) MENU ] key, then select
"Coordinate System" in the "GPS Setup" menu with
the [ ] / [ ] key.
4. Press the [ CALL ( ENT ) MENU ] key.
5. Press the [ ] / [ ] key to select the desired Co-
ordinate System. The Coordinate System can
be select to "ddd mm ss", "ddd mm.mm", or "ddd
mm.mmm".
6. Press the [ CALL ( ENT ) MENU ] key to store the
selected system.
7. To exit this menu and return to radio operation mode
press the [ 16/9 ] key or press the [ CLR ( WX )] key several times.
HX851
NOTE
Page 75