Standard Horizon HX851 Owner's Manual page 57

lected, then press the [ ] / [ ] key to correct the en-
try.
6. When finished entering the MMSI number, press and
hold the [ CALL ( ENT ) MENU ] key.
7. Press the [ CALL ( ENT ) MENU ] key to transmit the po-
sition request DSC call.
8. When the HX851 receives the position from the polled
vessel, a ringing alarm will sound, and the display
shows the position of the vessel and also transferred
to the GPS Chart plotter if connected.
9. Press any key to stop the alarm.
10. If you wish to display the position of the polled vessel
on the "WAYPOINT" screen, go to next step, other-
wise press the [ CLR ( WX )] key to return to radio opera-
tion.
11. Press the [ CALL ( ENT ) MENU ] key to enter the
"Waypoint Input" menu, then enter the desired waypoint
name (up to 11 characters), described previously (se-
lect the letter/number by pressing the [ ] / [
a n d m o v e t h e c u r s o r b y p r e s s i n g t h e
[ CALL ( ENT ) MENU ] / [ H/L (
12. The ID is the MMSI from the polled vessel.
13. When you are finished entering the waypoint name,
press and hold the [ CALL ( ENT ) MENU ] key several
times until replace the display to the "WAYPOINT"
Screen. The display indicates the distance and direc-
tion of the polled vessel, and also the compass indi-
cates the polled vessel by dot ( ) .
14. To stop navigating to the location of the position re-
quest call:
1) Press and hold down the [ CALL ( ENT ) MENU ] key until "Setup Menu"
appears.
2) Press the [ ] / [ ] key to select "Radio Setup".
3) Press the [ CALL ( ENT ) MENU ] key, then select "Display" with the [ ] /
[ ] key.
4) Press the [ CALL ( ENT ) MENU ] key, and select "Radio", "Position", "Navi-
gation" or "Compass" other than "Waypoint", and press the
[ CALL ( ENT ) MENU ] key.
HX851
)] key).
] key
Page 57