Standard Horizon HX851 Owner's Manual page 61

7. When finished entering the MMSI number, press
and hold the [ CALL ( ENT ) MENU ] key.
8. Press the [ CALL ( ENT ) MENU ] key again to send
your position to the selected vessel.
9. Press the [ CLR ( WX )] key to return to radio operation.
7.9.3 RECEIVING A DSC POSITION REPORT CALL
When another vessel transmits their vessels location to the HX851 the follow-
ing will happen:
1. When a Position Report Call is received, a calling alarm sounds 5 times and
NMEA DSC and DSE sentences are outputted on the charging cradle wires.
2. The display shows the position from the vessel
sending it's position and also transferred to any
compatible GPS Chart plotter if connected.
3. If you wish to display the position of the received
vessel on the "WAYPOINT" screen, go to next
step, otherwise press the [ CLR ( WX )] key to re-
turn to radio operation.
4. Press the [ CALL ( ENT ) MENU ] key to enter the
"Waypoint Input" menu, then enter the desired
waypoint name (up to 11 characters), described previously (select the let-
ter/number by pressing the [ ] / [ ] key and move the cursor by pressing
the [ CALL ( ENT ) MENU ] / [ H/L (
5. The ID is the MMSI from the received vessel.
6. When you are finished entering the waypoint name, press and hold the
[ CALL ( ENT ) MENU ] key several times until the
"WAYPOINT" display is shown. The display indicates
the distance and direction of the received vessel, and
also the compass indicates the received vessel by dot
( ) .
7. To stop navigating to the location of the position request call:
1) Press and hold down the [ CALL ( ENT ) MENU ] key until "Setup Menu"
appears.
2) Press the [ ] / [ ] key to select "Radio Setup".
3) Press the [ CALL ( ENT ) MENU ] key, then select "Display" with the [ ] /
[ ] key.
4) Press the [ CALL ( ENT ) MENU ] key, and select "Radio", "Position", "Navi-
gation" or "Compass" other than "Waypoint", and press the
[ CALL ( ENT ) MENU ] key.
HX851
)] key).
Page 61