Units Of Measure; Pinning; Sbas; Augmentation System) - Standard Horizon HX890 Owner's Manual
Class-h dsc gps transceiver
Hide thumbs
Also See for HX890:
- Firmware update instruction manual (5 pages) ,
- Owner's manual (107 pages)
Table of Contents
Advertisement
16.8 UNITS OF MEASURE
This section allows setting the display units of the speed, distance and altitude.
Press and hold
key
1. Press the [CH▼]/[CH▲] key to select the item to be set.
2. Press the [SELECT] soft key.
3. Press the [CH▼]/[CH▲] key to select the unit.
4. Press the [ENTER] soft key to store the new setting.
5. Press the [CLR] key to return to radio operation.
16.9 PINNING
This selection is used to enable or disable position updates when the vessel
is not underway. The default setting is "ON".
Press and hold
key
1. Press the [CH▼]/[CH▲] key to select "ON" or "OFF".
ON: When pinning is turned on, the HX890 will not update
its position unless the vessel travels over 10 Ft.
OFF: Whether the vessel is underway or stopped, the
HX890 continuously updates its position. This
improves accuracy of the position fix.
2. Press the [ENTER] soft key to save the new setting.
3. Press the [CLR] key to return to radio operation.
16.10 SBAS (Satellite Based Augmentation System)
This selection enables or disables SBAS such as WAAS, EGNOS and MSAS
as some areas (Australia for example) can have problems with GPS reception
with SBAS enabled. The default setting is "ON".
Press and hold
key
1. Press the [CH▼]/[CH▲] key to select "ON" or "OFF".
2. Press the [ENTER] soft key to store the new setting.
3. Press the [CLR] key to return to radio operation.
(
/
key)
(
/
key)
(
/
key)
SELECT
UNITS OF MEASURE
(
(
key)
SELECT
PINNING
(
(
key)
SELECT
D-GPS
(
key)
(
SELECT
/
key)
(
GPS SETUP
UNITS OF MEASURE
SPEED
DISTANCE
ALTITUDE
BACK
SELECT
ON
/
key)
(
GPS SETUP
PINNING
OFF
ON
BACK
SELECT
ON
/
key)
(
GPS SETUP
D-GPS
OFF
ON
BACK
key)
kts
nm
ft
SELECT
key)
ENTER
key)
ENTER
91
Advertisement
Table of Contents
