Gas Supply Connection - Dacor Epicure ER36D Installation Instructions Manual

Gas Connection
r
L1 terminal
Neutral terminal _
1_2terminal
Jumper link
L1 wire
White wire
L2 wire
Strain relief
3 Wire Appliance Cord
Connection -
Where Local Code Permits
L1
L2
10-50P Plug
@
o
o
t
i
Neutral
NOTE: The gas pressure regulator is pre-set at the factory for
the type of gas intended for use with the appliance. To verify that
the appliance is compatible with the type of gas available, check
the range rating label (see page 3 for location). Ranges intended
for use with LP gas wilt have "LP" as a part of the model number.
Consult your dealer if the range is not compatible with the type of
gas supplied.
Before sliding the range into the cabinet:
1. Make sure the gas supply valve is in the off position and that
power to the range is off.
2. Connect a flexible gas supply line to the gas shut-off valve
previously installed on the stub out. The gas line needs to be
long enough to allow the range to be pulled out for service.
3. Remove the gas regulator access cover.
4. Slide the end of the gas line under the back cover into the
regulator compartment from the bottom.
5. Connect the gas line to the regulator.
6. Turn all cooktop control valves to the "OFF" position. Turn on
the gas supply.
7. Check all lines and
connections for leaks
using a soap and
water solution.
8. After verifying that
there are no gas
leaks, turn off the
gas supply valve
connected to the
range to the "OFF"
position.
9. Replace the regulator
access cover.
ulator
connection
Gas line
Back of range
_::_acar 15