Preparing For Installation - Dacor Epicure ER36D Installation Instructions Manual

Hide thumbs Also See for Epicure ER36D:
Table of Contents

Advertisement

Preparing for Installation
IMPORTANT: Within the Commonwealth
of Massachusetts,
this
appliance must be installed by a licensed plumber or gas fitter.
Unpacking
the Range
Unpack the parts box and verify that all required components
have been provided. If any item is missing or damaged, please
contact your dealer immediately. Do not install a damaged or
incomplete appliance. The customer must report cosmetic issues
within 30 days of installation.
Parts
List
3 Grates
2 Small stack burner caps
2 Small stack burner rings
2 Large stack burner caps
2 Large stack burner rings
2 Crown burner caps
2 Crown burner rings
2 Crown burner heads
1 GlideRack
TM
oven rack
2 Standard size racks
3 18" Racks (ER48D only)
6 Knobs
Anti-tip bracket w/screws
Meat probe
Griddle
Wok ring
Stainless steel cleaner
Literature kit
Broiler pan/grill
See the use and care manual for a list of optional parts and
accessories.
Level and Adjust the Range Height
1.
Adjust the height by turning the bottom part of each leg
as shown. Raise or lower the range until the trim around
the cooktop area is slightly higher than the counter-top. If
installing with a raised vent, adjust the height so that the trim
matches the height of the vent's top in the down position.
Rear leg
Back of range
up _
Foot
(location varies)
* Distance to floor:
down
4 1/16" to 5 5/16"
2.
Use a level to make sure that the range does not tilt front to
back or side to side. Readjust the legs if necessary.
Install the Anti-Tip Bracket and Foot
1.
Locate the anti-tip foot and lower it until it is 1/16" (2 mm) off
the floor. See the diagram above.
2.
Locate the anti-tip bracket included in the parts box.
3.
Install the anti-tip bracket on the floor using the four (4)
included screws. The mounting location varies according to
the model. See the diagram below for location.
Back of
range
Range
right side
panel
/
ANTI-TIP
BRACKET PLACEMENT
Dimension
I
ER36D-
ER48D
J
7 1/2" (191 mm)
19" (483 mm)
K
6 1/2" (165 mm)
6 1/4" (159 mm)
dacar
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Epicure er36d-cEpicure er48d-cEpicure er48d

Table of Contents