Final Installation; Installing The Burner Knobs - Dacor Epicure ER36D Installation Instructions Manual

Final
1.
2.
3.
Re-installing
Installation
Peel the protective coating off of the range, including the
door.
Adjust the legs to the desired height.
Carefully slide the range into position in the cut-out. The rear
anti-tip leg should engage the anti-tip bracket.
the Oven Door(s)
Installing the Burner Knobs
NOTE: When installing the knobs, align the "D" shaped opening
on the back of the knob with the end of the valve shaft. Carefully
push the knob on until it stops.
There are two (2) different types of knobs supplied with the
range. The knobs for the center burners have the words "MAX
GRIDDLE" on them.
1. Put the knobs with the words "MAX GRIDDLE" on them onto
the inner (center burner) valve shafts.
1. Grasp the oven door on opposite sides and hold it at a 15 °
angle from the front of the oven. Slide the hinges into the
hinge openings, resting the bottom of the hinge arms on the
hinge receptacles. Continue to hold the door at a 15 ° angle
with one hand while pushing in on each of the bottom corners
of the door. Push until the notch on the bottom of each hinge
slips over the lower tip of each hinge receptacle.
2. Lower the door to the fully opened position.
3. Rotate the two hinge locks toward the oven.
4. Slowly and carefully open and close the door completely to
ensure that it is properly installed.
5. Remove any packaging from inside the oven(s).
Icons on Center Burner Knobs
2. Put the remaining knobs on the outer valve shafts.
Notch on bottom
of hinge
Lower lip of
hinge receptacle
Door Installation
Icons on Outer Burner Knobs
16 _::_acar