Dacor Epicure ER36D Installation Instructions Manual
Hide thumbs
Also See for Epicure ER36D:
- Use & care manual (40 pages) ,
- Installation instructions manual (24 pages) ,
- Planning manual (3 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dacor Epicure ER36D
Summary of Contents for Dacor Epicure ER36D
- Page 1 n stall at I o n n st r u ct I o n s ™ r p I c u r E an g Es For Use with Models: ER36D, ER48D Save TheSe InSTrucTIonS ThIS aPPLIance haS Been TeSTeD In accorDance WITh The LaTeST eDITIon oF anSI Z21.1 STanDarD For houSehoLD GaS aPPLIanceS.
-
Page 2: Table Of Contents
Common sense, caution, and care must be exercised when installing, maintaining, or operating an appliance. WarnInG ® Always contact Dacor about problems or conditions you do not WarnInG – NEVER cover any slots, holes, or passages in understand. -
Page 3: Important Safety Instructions
mporTanT afeTy nsTruCTIons To reduce the risk of fire, explosion, electric shock, serious injury, or death when installing or using this appliance, follow basic safety precautions, including the following: WarnInG Read the accompanying use and care manual before operating this appliance. Keep packaging materials away from children. -
Page 4: Customer Service Information
Model and serial number label located should be directed to your Dacor dealer or the Dacor ® ® inside grate. customer Service Department. Dacor ® Customer Service 1-800-793-0093 (U.S.A. -
Page 5: Planning The Installation
A 4-wire connection (not provided) is required to connect Finished Side the range to the junction box. The minimum wire gauge Panel suggested by Dacor ® is 10 AWG. Consult local building codes for the type and minimum wire gauge to use. -
Page 6: Cabinet Layout
◊ To reduce the risk of personal injury and to reduce be maintained. accumulated smoke in the room, Dacor ® strongly recommends installing a range hood. A range hood should Gas and electrical Service project horizontally a minimum of 5 inches beyond the face of ◊... -
Page 7: Preparing For Installation
nsTallaTIon nsTruCTIons reparIng for nsTallaTIon Install the anti-Tip Bracket and Foot WarnInG Locate the anti-tip foot and lower it until it is 1/16" (2mm) off WarnInG: the floor. See the bottom left diagram. • If the gas or electric service provided does not meet the Locate the anti-tip bracket included in the parts box. - Page 8 Special attention should be given to the lower flange in front of the island trim/backguard, which noTe: Dacor ® recommends that the 24-Inch backguard be must fit between the stainless steel side panels and over the installed by at least two people.
-
Page 9: Installation Instructions
nsTallaTIon nsTruCTIons Installing the optional Backguard, or Island removing the oven Door Trim (continued) WarnInG Fasten the backguard and the stainless steel trim piece in WarnInG: place with the chrome plated screws from the kit. • Do not attempt to disengage the hinge catches with the Secure the rear of the backguard to the back of the range door removed from the oven. -
Page 10: Electrical Connection
nsTallaTIon nsTruCTIons leCTrICal onneCTIon Remove the electrical access cover to expose the opening in WarnInG the range electrical panel. WarnInG: Feed the wires through the hole underneath the range • Wire the range only in compliance with local ordinances electrical panel and secure the conduit or appliance wire. •... - Page 11 nsTallaTIon nsTruCTIons MeThoD 1 - Four-Wire electrical System connection to Junction Box Separate the green and white appliance wires. power supply Connect the white appliance wire to the neutral (white) supply wire in the junction box. Connect the black appliance wire to the black (L1) power supply wire in the junction box.
- Page 12 nsTallaTIon nsTruCTIons MeThoD 3 - connecting the Green appliance Wire to a Grounded Supply Wire or Grounded cold Water Pipe, Where Local codes Permit WarnInG WarnInG: • Do not ground the appliance to a gas supply pipe or hot water pipe. •...
-
Page 13: Gas Supply Connection
nsTallaTIon nsTruCTIons upply onneCTIon Connect the gas line to the regulator. WarnInG Turn on the gas supply and check for leaks. WarnInG: Turn the gas supply off. • Do not apply excessive pressure when tightening gas Replace the regulator access cover. connections and fittings. -
Page 14: Installing The Burner Components
nsTallaTIon nsTruCTIons nsTallIng The urner omponenTs WarnInG WarnInG: Never attempt to operate the cooktop section of the range with any of the burner rings, burner caps, or grates removed. Spill Tray ◊ Remove the burner rings, burner caps, and grates from their shipping packages. -
Page 15: Installing The Burner Knobs
nsTallaTIon nsTruCTIons nsTallIng The urner nobs cauTIon Installing the range knobs in the wrong position may result in damage to the griddle included with the range. The knobs for the center burners are marked with the maximum griddle settings. There are two (2) different types of knobs supplied with the range. -
Page 16: Verifying Proper Operation
Repeat the above bake test or burner ignition test. If the appliance still does not work, contact an authorized ® DACOR service company at (800) 772-7778. ® Do not attempt to repair the appliance yourself. DACOR is not responsible for service required to correct a faulty installation. - Page 17 Specifications contained within are subject to change without notice. ® no liability is assumed by Dacor for changes in specifications. The information and images in this book are the copyright property of Distinctive appliances Inc. neither this book nor any...
Need help?
Do you have a question about the Epicure ER36D and is the answer not in the manual?
Questions and answers