Dacor ER36G Installation Instructions Manual
36-inch gas range
Hide thumbs
Also See for ER36G:
- Use and care manual (24 pages) ,
- Installation instructions manual (20 pages) ,
- Instructions (4 pages)
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dacor ER36G
Summary of Contents for Dacor ER36G
- Page 1 Installation Instructions Range Epicure ® 36-Inch For use with models ER36G and ER36GI THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. PartNo. 106554 Rev. D...
-
Page 2: Model Identification
Keep these installation instructions for future reference and the local building inspector's use. If you have questions or problems with installation, contact your View model/serial Dacor ® dealer or the Dacor Customer Service Team. For repairs to number label Dacor appliances under warranty call the Dacor Distinctive Service... - Page 3 Use common sense and caution when installing, maintaining or operating this appliance. Always contact the Dacor Customer Service Team about WARNING - Failure to install this appliance as specified problems or conditions you do not understand.
-
Page 4: General Safety Precautions
General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: If you receive a damaged product, immediately contact your dealer or builder. Do not insta I or use a damaged •... -
Page 5: Product Dimensions
Overall Dimensions - Side View Available Backguards - Side View 1) Trim thickness is 1/4" (6 mm) with optional self-rimming Not for use with self rimming installations. ER36G is kit installed (ER36GI only). not equipped for self-rimming installation. Standard on model ER36GI. Optional on model ER36G is designed for freestanding installations. -
Page 6: Electrical Power Supply Requirements
Gas Supply Requirements • Be certain that the range being installed is correct for the gas service being provided (natural gas or LP gas). Check your local building codes for the proper method of installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA 54. -
Page 7: Cabinet Layout
Notch counterto_ overhang to width of The range may be installed flush to the rear wall. Dacor cabinets Countertop overhang Countertop Height: Min: 35 1/2" (902 ram) 2 1/8"... -
Page 8: Gas And Electrical Locations
Gas and Electrical Locations The installation must allow for the following: Access to the gas shut-off valve when the unit is installed, Access to the electrical outlet, when the range is in place, The gas supply piping, gas shut-off valve and the electrical junction box or receptacle must be located so they do not interfere with the range when it is installed,... -
Page 9: Backguard Kit Installation
Slide the provided left and right trim pieces onto the Backguard Kit Installation range. The overhang on each piece goes toward the See page 3 for available model numbers and compatibility. back. Fasten the new trim pieces in place using the provided If installing a backguard other than the standard size, #8 x 1/4 Torx screws (3 each side). -
Page 10: Adjust The Range Height
11) Attach the self-rimming side panels included with the Self-Rimming Trim Installation (cont.) unit by snapping the ball studs on the front into the Re-attach the backguard using the supplied #8 x 1/4" back of the control panel and kick panel. The finished Torx screws. -
Page 11: Install The Anti-Tip Bracket
Door Removal Install the Anti-Tip Bracket Locate the anti-tip foot on the back of the range and Remove the door to make the range easier to move during turn it until the bottom of it is 1/16" (2 mm) off the floor. the installation process. -
Page 12: Gas Connection
Gas Connection IMPORTANT: The installed gas pressure regulator is pre- set at the factory for the type of gas intended for use with Make sure the gas is turned off at the gas supply the appliance. Verify that the appliance is compatible with valve before connecting the gas line. -
Page 13: Moving The Range To Final Location
Carefully slide the range into position taking the slack Moving the Range to Final Location out of the power cord as you push the unit into place. Peel the protective plastic coating off of the range, Be careful not to kink the power cord or gas line as you including the range door. -
Page 14: Cooktop Assembly
Cooktop Assembly 1) Remove the burner rings, burner caps and grates from their shipping cartons. Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the bottom of the burner ring is normal. -
Page 15: Verifying Proper Operation
Repeat the above tests. Connect the power cord to the electrical outlet. When If the appliance still does not work, contact Dacor the range is first connected, the oven indicator light Distinctive Service at (877) 337-3226. Do not attempt to flashes on and off for about 10 seconds while the repair the appliance yourself. - Page 16 :;uo m_F_ o .// _11' (_// BAKE'BRO[L KNOB LED o ,_/., OVEN CELLON LED Return o .// +5VDC q_F_ _///// < < m I::_car...
- Page 17 dacar...
- Page 18 =::_acar...
- Page 19 The Life of the Kitchen? American Made*Family Owned Dacor • 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 • Phone: (800) 793-0093 • Fax: (626)403-3130 • www.Dacor.com...
Need help?
Do you have a question about the ER36G and is the answer not in the manual?
Questions and answers