Electrical Connection - Dacor Epicure ER36D Installation Instructions Manual

Electrical Connection
Refer to the range rating label (see page 3) for power
requirements.
There are four possible ways to wire the range:
• 4 wire conduit
• 3 wire conduit (where local codes permit)
• 4 wire appliance cord (where local codes permit)
• 3 wire appliance cord (where local codes permit)
The sections below and on the following pages give directions for
connecting each type of wiring harness.
NOTE: Ranges equipped for use in Canada come from the
factory pre-wired. If installing a pre-wired range, skip to the Gas
Supply Connection section on page 15.
IMPORTANT:
• Do not disconnect any of the wires inside the range electrical
box unless instructed to do so.
• Make sure that the conduit or appliance cord is tong enough
to allow the range to be pulled out for service without
disconnecting it from power.
\
Put slack in electrical
wiring and gas line
For safety, replace the electrical access cover after
connecting the wiring.
Gas regulator
access cover
1
Electrical access cover
_Back of range
Connecting Conduit to the Range
NOTE: For connection of an appliance cord, see page 14.
1. Remove the range electrical access cover from the back of
the range.
2. If using a 4 wire connection, loosen the grounding screw and
remove the neutral to ground jumper link.
3. Remove the nut from the conduit strain relief (not included).
4. Slide the wires and the end of the strain relief into the hole on
the bottom of the range electrical box.
5. Before connecting the wires, slide the strain relief nut over
the wires and thread it onto the conduit strain relief inside the
box. Tighten into place.
6. Connect the white wire to the neutral terminal in the box.
7. Connect the black wire to the L1 power supply terminal.
8. Connect the red wire to the L2 power supply terminal.
9. If using a 4 wire connection, connect the green wire to the
grounding screw inside the box.
10. Replace the range electrical access cover.
10 _a=ar