Dacor ER36D Installation Instructions Manual
Installation instructions
Hide thumbs
Also See for ER36D:
- Use & care manual (40 pages) ,
- Installation instructions manual (23 pages) ,
- Planning manual (3 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dacor ER36D
Summary of Contents for Dacor ER36D
-
Page 1: Installation Instructions
Installation Instructions Epicure Range ® For use with models ER36D, ER36D-C, ER48D, ER48D-C THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. Part No. 100843 Rev. T... -
Page 2: Table Of Contents
: Keep these installation instructions for future reference and the local building inspector’s use. Specifications contained within are subject to change without notice. ® No liability is assumed by Dacor for changes in specifications. © 2007 Dacor, all rights reserved. -
Page 3: Important Safety Instructions
Use common sense and caution when installing, maintaining or operating this or any other appliance. WARNING Always contact the Dacor Customer Service Team about problems WARNING – NEVER cover any slots, holes or passages on and conditions that you do not understand. -
Page 4: General Safety Precautions
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual before operating this appliance. •... -
Page 5: Customer Service Information
Customer Service Information If you have questions or problems with installation, contact your Model Identification Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive ER36D-C-SCH/NG/H Service line. Whenever you call, have the model and serial number of the appliance ready. -
Page 6: Planning The Installation
Have a minimum rating of 250 Volts @ 30 Amps for make sure it is equipped for high altitude operation. Refer to model ER36D, 250 Volts @ 50 amps for model ER48D the range rating label and the table on page 3 to determine the correct model. -
Page 7: Product Dimensions
(40 mm) (76 mm) 1 1/16” (27 mm) to cooking surface (top of grates) from top of trim (940 mm) Finished side panel (908 mm) ** Optional Width: ER36D - 35 7/8” (911 mm) ER48D - 47 7/8” (1216 mm) -
Page 8: Cabinet Layout
• Access to the remote circuit breaker panel/fuse box, when the • The range may be installed flush to the rear wall. Dacor range is in place. strongly recommends installing a non-combustible material • The gas supply piping and shut-off valve, and the electrical... -
Page 9: Installation Instructions
The mounting location varies according to the model. See the diagram below for location. Bracket Top view Range Back of right side range panel ANTI-TIP BRACKET PLACEMENT Dimension ER36D ER48D 7 1/2” (191 mm) 19” (483 mm) 6 1/2” (165 mm) 6 1/4” (159 mm) -
Page 10: Installing Backguard
Install the backguard before making the range gas and electrical connections. • Dacor recommends that the 24 inch backguard be installed by at least two people. To install a backguard: Remove the thirteen (13) screws on the front and back of the island trim and slide the trim off the unit. -
Page 11: Removing The Oven Door
Installation Instructions Fasten the backguard and the stainless steel trim piece in Removing the Oven Door place with the five (5) existing chrome plated screws. WARNING Secure the rear of the backguard to the back of the range with the eight (8) existing hex screws. •... -
Page 12: Electrical Connection
There are four possible ways to wire the range: • Improper connection of the electrical wiring can cause an • 4 wire conduit electric shock hazard and damage the appliance. Dacor • 3 wire conduit (where local codes permit) is not responsible for damages resulting from improper installation. - Page 13 Installation Instructions L1 terminal Neutral terminal L2 terminal Jumper removed Grounding screw Red wire Green wire White wire Black wire Conduit strain relief nut Connecting 4 Wire Conduit to Range L1 terminal Neutral terminal Jumper link L2 terminal Black wire White wire Red wire Bare wire...
- Page 14 Installation Instructions Electrical Connection (Continued) Connection to Connecting the Conduit to the House power supply Electrical Junction Box WARNING Junction box Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit. Wire nut NOTES: 4 places WHITE...
- Page 15 Installation Instructions Separate No. 10 (minimum) Connection to copper grounding wire power supply Junction box Fasten clamp tightly on pipe Wire nut 4 places Connection to appliance (Page 10) 4 Wire Conduit Connection to Junction Box with External Ground No. 4 Meter copper wire Metal...
- Page 16 Installation Instructions Electrical Connection (Continued) Slide the end of the appliance cord into the strain relief from the bottom of the box. Connecting an Appliance Wire to the Connect the white (neutral) wire to the neutral terminal in the box. Range - Where Local Code Permits Connect the L1 wire to the L1 power supply terminal in the box.
-
Page 17: Gas Supply Connection
Installation Instructions Gas Connection WARNING • Make sure the gas supply valve is off and that the power to Bare wire the range is turned off at the circuit breaker or fuse box prior connections to connecting the gas line. •... -
Page 18: Final Installation
Installation Instructions Final Installation Installing the Burner Knobs Peel the protective coating off of the range, including the CAUTION door. Installing the range knobs in the wrong position may result Adjust the legs to the desired height. in damage to the griddle included with the range. The knobs Carefully slide the range into position in the cut-out. -
Page 19: Installing The Burner Components
Stack burner • Gently set the grates on top of the spill tray. Put the legs of each grate inside the corresponding dimples. On model ER36D, the largest grate goes in the center. Ridge on bottom of burner cap STEP 3: Install burner cap. -
Page 20: Verifying Proper Operation
Repeat the above bake test or burner ignition test. If the appliance still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. Have the model and serial numbers available when you call. - Page 21 Notes...
- Page 22 Notes...
- Page 24 Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com...
Need help?
Do you have a question about the ER36D and is the answer not in the manual?
Questions and answers