Digisol DG-SC5800PI User Manual page 34

Static IPv4 / IPv6: Assign an IPv4 / IPv6 address to IP camera
manually. If you don't have a DHCP server on your local area
network, you must use this option to specify an IP address.
Enable UPnP Discovery: Check this box to enable other devices
on the network to discover the presence of this IP camera by
UPnP. It's recommended to enable this function.
Enable UPnP Port Mapping: When UPnP is enabled, check this
box to enable UPnP's port mapping.
PPPoE Select this option to use PPPoE to connect to network. You have
to input PPPoE username and password assigned by network
operator to get connected.
HTTP Port Input IP camera's web connection port number here. When this
port number is changed, you need to change web browser's port
number you used to connect to IP camera.
For example, IP camera's IP address is 192.168.2.3, and if you
changed
'http://192.168.2.3:82' in web browser's address bar to access IP
camera's web configuration interface.
RTSP Port Input RTSP port number. When this port number changes, you
must change corresponding settings in external network devices
(NVR or CMS software) so they can receive this IP camera's
video.
RTP Data Port Input RTP data port number here.
When you finish with above settings, click 'Apply' button to save changes.
IP Address(IPv4): Input IPv4 IP address
IP address (IPv6): Input IPv6 IP address
Prefix Length: Input IPv6 IP address prefix length (0-128)
Subnet Mask: Input subnet mask
Gateway: Input gateway address
Primary DNS: Input DNS server's IP address
Secondary DNS: Input backup DNS server's IP address, you
can leave this field blank.
HTTP port
34
DG-SC5800PI User Manual
number to 82, please input