Table of Contents
Advertisement
Configuring the Network
Configuring User Targets
In Block account, select
time, or forever for a total block
3. Select the High security password policy
High security password policy checkbox to enable the high security
password policy; clear the checkbox for the standard security policy to apply.
password policy; clear the checkbox for the standard security policy to apply.
password policy; clear the checkbox for the standard security policy to apply.
4. Select the Enable OSD password
access to the OSD. By default, p
5. In Disconnect after, select the timeout inactivity period after whi
disconnected from the system. Select
6. To use your preferred SSH client
use your preferred SSH client to communicate directly to the serial device via
the specified TCP ports:
1. Select the Enable direct SSH Connection
2. Select Serial 1 TCP port
Serial 1 TCP port and Serial 2 TCP port values. Their default ports
4001 and 4002, respectively.
3.9 Configuring User Targets
Configuring User Targets
By default, administrators are allowed access to all servers. For other users, you must
By default, administrators are allowed access to
define the access rights of each user separately.
define the access rights of each user separately.
Perform the following procedure for each User.
Perform the following procedure for each User.
To configure User targets:
1. From the configuration menu, select
From the configuration menu, select User Targets.
The User Targets page appears.
36 | Smart 216/232 IP
select for period to block the account for a specified period of
or a total block.
SD password checkbox, to require a password for local user
checkbox, to require a password for local user
. By default, password is disabled.
, select the timeout inactivity period after which the user is
system. Select No Timeout to disable timeout.
communicate directly to the serial device via
direct SSH Connection checkbox.
, respectively.
appears.
to block the account for a specified period of
checkbox to enable the high security
all servers. For other users, you must
ch the user is
ports are
Advertisement
Table of Contents
