Configuring The Network; Boot-Up Process - Tripp Lite 0SU70036 User Manual

Configuring the Network

Boot-Up Process

3 Configuring the Network Configuring the Network
After the system has been installed and all connections have been made, you must After the system has been installed and all connections have been made, you must After the system has been installed and all connections have been made, you must
configure the Smart 216/232
1. Configure Smart 216/232
 Device ID settings
 Smart 216/232 IP's IP address
 Centralized Management Centralized Management
2. Add, edit, remove, and block system Users Add, edit, remove, and block system Users.
3. Configure the KVM switch settings Configure the KVM switch settings.
4. Configure the Serial port settings Configure the Serial port settings.
5. Configure the security settings Configure the security settings.
6. Configure the user targets. Configure the user targets.
7. Configure the system date
8. Configure power devices. Configure power devices.
9. Configure power outlets.
You can also perform the following additional operations, as required: You can also perform the following additional operations, as required:
1. Install an SSL certificate.
2. Upgrade firmware.
3. Upgrade RICCs/ROCs.
4. Restore factory settings.
5. Back up and restore configuration data. Back up and restore configuration data.
3.1 Boot-Up Process Up Process
By default, Smart 216/232 IP
DHCP (Dynamic Host Configu
assigns the Smart 216/232 IP
You can identify the IP address from the OSD at the local position. Also, where there You can identify the IP address from the OSD at the local position. Also, where there You can identify the IP address from the OSD at the local position. Also, where there
is no DHCP server, you can set the IP address locally via the OSD
following procedure.
To set the IP address locally via the OSD set the IP address locally via the OSD:
1. From the local keyboard, press From the local keyboard, press Shift twice.
The OSD Main window app
22 | Smart 216/232 IP
216/232 IP system as follows:
216/232 IP's network settings, which includes configuring: network settings, which includes configuring:
's IP address
date and time.
.
IP boots with an automatically assigned IP addr
uration Protocol) server on the network. The DHCP server
IP a valid IP address, gateway address, and subnet mask. a valid IP address, gateway address, and subnet mask.
set the IP address locally via the OSD, as described in the
appears.
ress from a
The DHCP server
, as described in the