Table of Contents
Advertisement
7 Lock the two camera fixing lock knobs,
and peel off the dome cover protection
sheet.
When the camera is mounted on the ceiling
0
mount section, lower the camera fixing lock
knobs (x2) in the direction of the arrow and
secure the camera such that it does not fall
off.
After installation is complete, peel off the
0
dome cover protection sheet.
Caution
The camera may fall if the camera fixing lock
0
knobs (x2) are not locked. Be sure to check
that the lock knobs are firmly locked.
Improper mounting may cause the camera
0
to fall off. After mounting, check that the
camera is mounted securely.
Installation of the camera is complete. Next, set
the IP address of the camera.
(A p.38 [IP Address Setting Procedure] )
Removing the Camera
1 Release the lock by sliding the camera
fixing lock knobs toward the ceiling.
2 Press the two camera fixing lock
knobs from both the left and right
sides to remove the camera unit.
3 Remove the fall prevention wire by
performing the mounting procedures
in the reverse sequence.
Camera
fixing lock
knob (x2)
Dome cover
protective sheet
Installation and
Connection Preparations
(VN-H657WPBU)
Be sure to put on protective glasses to protect your
eyes from falling objects when mounting the
camera.
Setting Up the Wall
1 Make a hole in the wall.
Make a hole (Φ45 mm) for the connecting
0
cables to pass through.
Note :
Check the strength of the wall. A less firm wall
0
may cause the unit to fall.
2 Install the anchor bolts for mounting
the camera.
Install 4 anchor bolts (M8 ´ 35 mm and
0
above) to mount the camera.
3 Install the anchor bolt for mounting the
fall prevention wire.
Install the anchor bolt to mount the fall
0
prevention wire 30 mm below the center of
the upper two anchor bolts that are used to
mount the camera.
152
126
63
Anchor bolt to
mount the fall
prevention wire
Mounting the Camera (VN-H657BU)
Anchor bolts to
mount the camera
31
Advertisement
Table of Contents
