Preparation Procedure; Step 1 Connection And Installation - JVC VN-C655 Instructions Manual

Preparation Procedure

Set the camera in the following procedure.

Step 1 Connection and Installation

Firstly, make a hole on the ceiling and connect the power cable, LAN cable,
alarm and others to the terminal of the ceiling-mounting bracket of this unit.
Then, install the camera to a fixer, etc. Fix a wire securely for preventing the
camera from falling off.
Step 2 Setting the Network
Install the software [V.Networks Controller], and set the network for the PC
and VN-C655. Also perform the setting with [V.Networks Setup Tool] and reg-
istration of the connected camera with [V.Networks Controller].
❈ If multiple PCs are in use, first turn on the power for one PC and proceed to 2-4
Other Settings with V.Networks Setup Tool. Only then, turn on the power to a sec-
ond PC and go on to 2-4. Repeat the procedure for other PCs.
Step 3 Setting with V.Networks Controller
Use the installed V.Networks Controller to perform the settings for Auto Pan,
Auto Patrol, Auto Trace, Picture Quality, Preset Position, Alarm and others.
Step 4 Operations with V.Networks Controller
With V.Networks Controller, Preset Position can be selected as well as start-
ing and stopping Auto Pan, Auto Trace and Auto Patrol.
☞
Page 14
☞
Page 23
(☞
Page 15)
☞
Page 50
☞
Page 72
13