Base Unit Network Port; Standard Nic Configuration - Maxtor NAS 6000 Administration Manual

MaxAttach NAS 6000 Administration Guide
To determine which NICs are installed in your system, locate the card cage at the back of
the MaxAttach NAS 6000 and match the connector patterns with those shown in the
diagram.
Figure #33

Base Unit Network Port

Every system is equipped with a standard IEEE 802.3/IEEE 802.3U-LAN-compliant
10BaseT/100BaseTX Ethernet port. It is supplied on the CPU I/O Panel of the Maxtor
MaxAttach NAS 6000 Base Unit chassis.
The LAN connector for this port is a standard RJ-45 type, compatible with standard CAT
3, 4, and 5 UTP cabling for 10BaseT operation (10 Mb/s) and Cat-5 UTP cabling for
100BaseTX operation (100 Mb/s).

Standard NIC Configuration

The software drivers for each NIC have been pre-installed at the factory. There is no user
configuration required other than entering local area network parameters (IP address, server
name, domain and workgroup, etc.).
Every installed NIC should be connected to a separate subnet and be assigned a unique IP
address. The architecture of the network permitting, clients can access the MaxAttach with
any of its IP addresses.
Chapter #3 - Overview - Microsoft Windows O/S Version 2.0
11/07/01 -- Revision 2.0.03A
Base Unit Back Panel NIC Identification
Chapter #3 - Overview - Microsoft Windows O/S Version 2.0
65
Network Configuration
000001628