Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
Optionally, an administrator can modify the default RAID configuration and leave one or
two drives available as hot spare drives. These are drives that are powered up, but unused in
any array. In the event of a drive failure, the failed drive drops offline and is replaced
automatically by the hot standby drive. The RAID rebuild process starts automatically and
immediately.
Figure #15
CPU I/O Panel
The CPU I/O Panel is located on the Base Unit's Back Panel and it is the primary
diagnostic and administration interface into the MaxAttach NAS 6000.
Figure #16
It provides connections for:
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
11/07/01 -- Revision 2.0.03A
Hot Swappable Hard Disk Drive Carrier Diagram and Photo
CPU I/O Panel Above the EMU Connector Panel
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
Description of System Components
34
000001628
Advertisement
Table of Contents
