Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
Determining Your System's NIC Configuration
There is a five-slot card cage in the MaxAttach NAS 6000 Base Unit. The card cage holds
a video card, a RAID Controller Card, and a SCSI connector. The two remaining slots
hold the NICs. To determine which NICs are installed in your system, locate the card cage
at the back of the MaxAttach NAS 6000 and identify the three standard system cards by
their connectors (these may occupy any slot):
The Video Card has a 15-pin DSUB connector.
n
The RAID Disk Controller Card has 4 high-density 68-pin SCSI connectors.
n
The SCSI Connector Card has a single 68-pin connector.
n
In the remaining two card cage slots, look at the connectors and compare them to the
n
examples shown in the following diagram.
Figure #17
The manufacturer and configuration of the NICs may differ from your system's
conjuration.
Hot Swappable Fans and Blower
To provide maximum system life, each chassis enclosure comes with two Back Panel fans
and a single Blower. In the event of a failure, each unit is hot swappable with no loss of
system up time.
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
11/07/01 -- Revision 2.0.03A
Network Interface Cards I/O Ports Diagram
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
Description of System Components
36
000001628
Advertisement
Table of Contents
