Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
You may have alert e-mail sent to multiple addresses, simply type the addresses
n
into the To box, separated by a comma.
3.
In the With box, type the SMTP gateway name or IP address of the SMTP server.
4.
To test the settings, choose Test.
After clicking the Test button, test e-mail will be sent.
n
If the SMTP service is not installed on your computer, or there is no network
n
cable, you will receive the error message "Test e-mail cannot be sent out."
If you do not receive the test e-mail at all, even though the message "Test
n
e-mail has been sent out. Please check administrator's mailbox" has been
displayed in the Web UI, the error has most likely been caused by the SMTP
server.
To clear this error, reset the SMTP server name.
n
5.
Choose OK.
Backing up and Restoring the O/S
From this page you can choose to back up or restore the operating system (O/S).
To back up or restore the OS
1.
On the primary navigation bar, choose Maintenance.
2.
Choose Backup.
3.
Logon to Terminal Services Advanced Client. The backup application will start
automatically.
4.
When you are finished, close the application by clicking the X in the upper right
hand corner. This will log you off from the Terminal Services Advanced Client.
It may take a few moments for the session to log off when closing the application.
Chapter #10 - O/S 2.0 - Maintenance
11/07/01 -- Revision 2.0.03A
NOTE
Backing up and Restoring the O/S
240
Chapter #10 - O/S 2.0 - Maintenance
000001628
Advertisement
Table of Contents
