Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
AC-OK Indicators
n
These indicators remain lit as long as AC power is supplied to the power
n
supplies.
If a lamp is off, it indicates that the AC power has been interrupted to the
n
power supply. This could indicate the supply's power cord is detached, the
power supply is turned off, the supply's circuit breaker has opened, or that there
is an open in the internal AC wiring harness.
DC-OK Indicators
n
These indicators remain lit as long as the supply's DC voltages are normal.
n
If a lamp is off, it indicates either the AC power is off (check the supply's
n
AC-OK indicator) or one or more of the DC voltages is out of its normal
range.
If a single DC-OK indicator is off, the system may still function properly using the other power
supply. However, you should take corrective action as soon as possible.
LCD Alert Panel
The front-panel LCD (liquid crystal display) alert panel is a small 2.25"W x 1.25"H -
57mmW x 37mmH display with a resolution of 128 pixels W x 64 pixels H.
Figure #10
When the MaxAttach unit is housed in a system cabinet, each unit's alert messages can be sent to
the LCD panel on the cabinet. Up to three MaxAttach servers can be supported by the cabinet LCD
alert panel.
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
11/07/01 -- Revision 2.0.03A
NOTE
NAS 6000 LCD Front Panel Location and Display Areas
NOTE
Chapter #2 - Overview - MaxAttach NAS 6000 Hardware
27
LCD Alert Panel
000001628
Advertisement
Table of Contents
