Table of Contents
Advertisement
MaxAttach NAS 6000 Administration Guide
Changing Administration Web Site Properties
To change the administration web site properties
1.
On the primary navigation bar, choose Network.
2.
Choose Administration Web Site.
3.
On the Administration Site Properties page:
4.
Specify whether to use All IP addresses or Just this IP address.
5.
If you choose to use Just this IP address, use the list to select the IP address you
want to use.
6.
If changing the port for non-encrypted access, type the new port number in the Port
for non-encrypted access box.
7.
If changing the port for encrypted access, type the new port number in the Port for
encrypted (SSL) access box.
8.
Choose OK.
Telnet
The Telnet Administration Configuration feature allows you to administer your
Windows® Powered server appliance from a remote system using the Telnet protocol.
You can log onto the system from a remote Telnet client and run character-mode
applications on the server appliance. The Telnet server included with your server appliance
supports a maximum of two Telnet clients at any time, unless otherwise specified by your
server appliance hardware manufacturer.
Configuring System for Telnet Administration
To configure the MaxAttach NAS 6000 for Telnet administration
1.
On the primary navigation bar, choose Network.
2.
Choose Telnet.
3.
Select the Enable Telnet access to this appliance check box.
4.
Choose OK.
Chapter #5 - O/S 2.0 - Network Configuration
11/07/01 -- Revision 2.0.03A
Chapter #5 - O/S 2.0 - Network Configuration
155
Telnet
000001628
Advertisement
Table of Contents
