Programming Features; User Programmable Features - Excalibur RS-230-DP Operation Manual

Step 1 Turn the ignition key "On", then "OFF"
Step 2 within 5 seconds of step 1, press the valet switch 5 times to access user
features (10 times to access installer features).
~ The parking lights and the status light will turn on.
Step 3 within 10 seconds of step 2, press the valet switch the number of times cor-
responding with the desired feature's number.
~ The status lights and the parking lights will flash equal to the selected feature.
Step 4 Change the feature by pressing the brake pedal the same number of times
that corresponds with the desired setting.
~ The status lights and the parking lights will flash equal to the selected setting.
Step 5 If you wish to change more features, repeat steps 3 & 4 at this time.
Step 6 To exit programming, turn the ignition key "On" then "OFF". Or, you can wait
10 seconds for programming mode to expire. The lights will turn off.
This group of User Programmable Features are all accessed as a group in the first
level of features' programming. These features have a direct affect upon the sys-
tem's operations, so the programming and operation of each are described.
Feature #1 Remote Start Run Time
10 Minutes (press the brake pedal 1 time to program) - DEFAULT
5 Minutes (press the brake pedal 2 times to program)
15 Minutes (press the brake pedal 3 times to program)
20 Minutes (press the brake pedal 4 times to program)
This feature sets the period of time that the engine will run after being remotely
started. If the engine is not stopped by controller/transmitter command or a safety
circuit violation, the engine will automatically stop upon the expiration of the selected
time period. Caution: The remote engine starting feature should NEVER be
used when the vehicle is parked in an enclosed structure or garage.
Feature #2 Steady/Flashing Lights During Remote Start
Steady (press the brake pedal 1 time to program) - DEFAULT
Flashing (press the brake pedal 2 times to program)
This Feature configures the operation of the vehicle's parking lights during the
remote start operation. The default setting turns on the parking lights during remote
start; the other setting flashes the parking lights on and off during remote start.

Programming Features

User Programmable Features

7