Programming Transmitters; Programming Features - Excalibur RS-260-EDPB Operation Manual

condition, it will not respond to the transmitter, nor will the system reset automatically
after 60 seconds, and it can only be disengaged by:
Step 1 Turning the vehicle's ignition off.
Step 2 Turning the ignition back on.
Step 3 Within 5 seconds, perform an Emergency Override using the Valet Switch.
TyPES OF AnTi-cARJAcKinG PROTEcTiOn
ignition Activated Anti-carjacking activates every time the vehicle's ignition is
turned on. The Valet Switch must be pressed within 60 seconds of activating to can-
cel Anti-Carjacking.
Door Anti-carjacking activates when a door is opened after the vehicle is started
and the engine is running. The Valet Switch must be pressed within 60 seconds after
activation to cancel Anti-Carjacking.
Standard Programming: This method to program additional or replacement trans-
mitters does not affect the Unauthorized Transmitter Alert (UTA) feature. Before you
begin, have all transmitters which are to operate the system at hand.
Step 1 Then, turn the ignition "on" (do not crank the engine).
Step 2 Within 5 seconds of Step 1, press the Valet Switch 5 times. The siren/horn
will briefly sound & the status light will turn on, confirming that the system is ready to
learn a transmitter code.
Step 3 Press the "start" button on each transmitter one at a time. The system will
chirp the siren/horn once & the status light will turn off briefly to confirm that each was
learned. If a code is not received within 10 seconds of Step 2, the learning process
will automatically exit.
Step 4 Then, turn the ignition "off" or wait 10 seconds to exit programming mode.
A matrix of all programmable features and their options are on the last page of this
guide. For detailed information on each feature, please refer to the next section. Use
the procedure below to make any necessary changes.
TO mAnuALLy chAnGE FEATuRES:
Step 1 Turn the ignition key "ON", then "OFF".
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user
features (Press 10 times to access installer features).
~ The siren/horn will sound and the status light will turn on.
Step 3 Within 10 seconds of step 2, press the valet switch the number of times cor-
responding with the desired feature's number.
~ The siren/horn will chirp equal to the selected feature.
Step 4 Change the feature by pressing the transmitter button OR brake pedal the
same number of times that corresponds with the desired setting (make all presses
before hearing any chirps). NOTE: some cars require the ignition to be on for the
brake circuit to operate. In this case, turn on the ignition before this step.
~ The siren/horn will chirp equal to the selected setting.
Step 5 If you wish to change more features, repeat steps 3 & 4 at this time.
Step 6 To exit programming, turn the ignition key "ON" then "OFF". Or, it will
exit automatically after 10 seconds of no activity.
Anti-carjacking Protection (cont'd)

Programming Transmitters

Programming Features

7