Excalibur RS-230-DP Operation Manual page 9

Feature #4 Satellite Relay Port Green wire Function
Starter
Pulse After Engine Start
Status Output (press the brake pedal 3 times to program)
Domelight
This feature changes the operation of the green wire (negative) on the satellite relay
port. This gives you the flexibility to accomodate certain vehicles that require any
out-of-the-ordinary pulses or remote start timing.
Starter setting operates as a secondary START output. This will have the same
pulse timing as the large Violet wire on the main harness.
Pulse After Start setting will give a 0.8 second pulse immediately after the engine
starts and is running.
Status Output setting will behave like the ignition output except it turns on 1.5
seconds earlier than the primary ignition output..
Domelight provides domelight supervision output. It will turn on when the system is
unlocked and after turning the ignition "off".
Feature #5 Extended Starter Cranking Time
0.7 Second (press the brake pedal 1 time to program) - DEFAULT
1.00 Second (press the brake pedal 2 times to program)
1.5 Seconds (press the brake pedal 3 times to program)
2.25 Seconds
(press the brake pedal 4 times to program)
This feature determines the crank time of the 1st start attempt when in "Tachless"
mode. If the engine doesn't start on the first attempt, it will retry up to 3 more times
extending the crank time by an additional 0.2 second with each attempt..
Feature #6 Low Temp Crank Extender
0ms (Off) (press the brake pedal 1 time to program)
200ms (press the brake pedal 2 times to program) - DEFAULT
300ms (press the brake pedal 3 times to program)
400ms (press the brake pedal 4 times to program)
when the vehicle's interior temperature is below freezing, this feature adds extra
crank time to the base timing (see installer feature #5). It applies to tachless modes
only (installer feature #2)
Feature #7 Unlock Output Functions
0.8 Second Output
3 Second Output
Double 0.8 Sec Unlock
This single feature gives the installer several needed options, to match the system's
doorlocking outputs to suit different vehicle requirements.
0.8 Second Outputs on the unlock output.
3 Second Outputs on the unlock output.
Double 0.8 Sec Unlock Output
Installer Programmable Features (cont'd)
(press the brake pedal 1 time to program) - DEFAULT
(press the brake pedal 2 times to program)
(press the brake pedal 4 times to program)
(press the brake pedal 1 time to program) - DEFAULT
(press the brake pedal 2 times to program)
(press the brake pedal 3 times to program)
9