Programming Transmitters; Programming Features - Excalibur RS-360-EDP Operation Manual

Standard Programming: This method to program additional or replacement trans-
mitters does not affect the Unauthorized Transmitter Alert (UTA) feature� Before you
begin, have all transmitters which are to operate the system at hand�
Step 1 Then, turn the ignition "on" (do not crank the engine)�
Step 2 Within 5 seconds of Step 1, press the Valet Switch 5 times� The siren/horn will
briefly sound, confirming that the system is ready to learn a transmitter code.
Step 3 Press the "lock" button on each transmitter, one at a time� The system will
chirp the siren/horn once to confirm that each was learned. If a code is not received
within 10 seconds of Step 2, the learning process will automatically exit�
Step 4 Then, turn the ignition "off" or wait 10 seconds to exit programming mode�
If the Unauthorized Transmitter Alert feature is on, programming a transmitter to the
system will activate the "UTA" warning and the extended Status Light indication� For
the next 48 hours, the siren/horn will sound a brief series of chirps every time the
vehicle's ignition key is turned on�
Special Programming procedure to turn on the UTA feature: Use this method to
program transmitters or optional controllers, and to turn on the Unauthorized Trans-
mitter Alert feature�
Follow the same steps as the Standard Programming, but on any transmitter/con-
troller being programmed instead of pressing the "lock" button, press the "lock" and
the "unlock" buttons together� This action turns on the Unauthorized Transmitter
Alert feature and at the same time programs the transmitter or controller to operate
the system�
Once the Unauthorized Transmitter Alert feature is turned on, the warning will
sound for 48 hours after any transmitter programming� This feature can only be
turned off again by sending the system back to Omega for a reset�
A matrix of all programmable features and their options are on the last page of this
guide� For detailed information on each feature, please refer to the next section� Use
the procedure below to make any necessary changes�
TO mANUALLY ChANGE FEATURES:
Step 1 Turn the ignition key "ON", then "OFF" (do not crank the engine)�
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user
features (Press 10 times to access installer features)�
~ The siren/horn will sound and the status light will turn on�
Step 3 Within 10 seconds of step 2, press the valet switch the number of times cor-
responding with the desired feature's number�
~ The siren/horn will chirp equal to the selected feature.
Step 4 Change the feature by pressing the remote button that matches the desired
setting�
~ The siren/horn will chirp equal to the selected setting.
Step 5 If you wish to change more features, repeat steps 3 & 4 at this time�
Step 6 To exit programming, turn the ignition key "ON" then "OFF"� Or, it will exit
automatically after 10 seconds of no activity�

Programming Transmitters

Programming Features

11