Table of Contents
Advertisement
Programming Features
A matrix of all programmable features and their options are on the last page of this
guide For detailed information on each feature, please refer to the next section Use
the procedure below to make any necessary changes
TO mAnuALLy ChAnGE FEATuRES:
Step 1 Turn the ignition key "ON", then "OFF"
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user
features (Press 10 times to access installer features)
~ The siren/horn will sound and the status light will turn on
Step 3 Within 10 seconds of step 2, press the valet switch the number of times cor-
responding with the desired feature's number
~ The siren/horn will chirp equal to the selected feature
Step 4 Change the feature by pressing the brake pedal the same number of times
that corresponds with the desired setting (make all presses before hearing any
chirps) NOTE: some cars require the ignition to be on for the brake circuit to
operate. In this case, turn on the ignition before pressing the brake.
~ The siren/horn will chirp equal to the selected setting
Step 5 If you wish to change more features, repeat steps 3 & 4 at this time
Step 6 To exit programming, turn the ignition key "ON" then "OFF". Or, it will exit
automatically after 10 seconds of no activity
user Programmable Features
Feature #1 - Remote Start Run Time
10 minutes
(press "brake" 1 time to program) - DEFAuLT
5 minutes
(press "brake" 2 times to program)
15 minutes
(press "brake" 3 times to program)
20 minutes
(press "brake" 4 times to program)
This sets the maximum amount of time that the remote start will keep the engine
running if it is not shut down by other methods
Feature #2 - Flashing Light Confirmations
unlock: On, RS: On
unlock: On, RS: Flash
unlock: Flash, RS: On
unlock: Flash, RS: Flash (press "brake" 4 times to program) - DEFAuLT
This feature affects the parking light confirmations for system unlock & remote start
functions With the above options, you can select any combination of:
unlock: Flash - Flashes twice after unlock
unlock: On - Flashes twice then stays on for 30 seconds after unlock
RS: On - Stays on during remote start mode
RS: Flash - Flashes once every 15 seconds during remote start mode
Feature #3 - Confirmation Chirp Volume
Low (softest)
medium Low
medium high
high (loudest)
This feature allows the choice of different chirp volume levels, and when programming
it, each selection will be confirmed in the chosen volume making it easy to
8
choose the most suitable setting
(press "brake" 1 time to program)
(press "brake" 2 times to program)
(press "brake" 3 times to program)
(press "brake" 1 time to program)
(press "brake" 2 times to program)
(press "brake" 3 times to program) - DEFAuLT
(press "brake" 4 times to program)
Advertisement
Table of Contents
