Problems With Nec Expressbuilder - NEC N8800-103F User Manual

Problems with NEC EXPRESSBUILDER

When the server is not booted from the NEC EXPRESSBUILDER CD-ROM, check the following:
Did you set the NEC EXPRESSBUILDER CD-ROM during POST and restart the
server?
→ If you do not set the NEC EXPRESSBUILDER CD-ROM during POST and
restart the server, an error message will appear or the OS will boot.
Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS setup utility of the server.
Use the BIOS setup utility to change the boot device order to boot the system
from the DVD-ROM drive first.
<Menu to check: [Boot]>
When an error occurs while the NEC EXPRESSBUILDER is in progress, the following message
appears. After this message appears, check the error and take the appropriate corrective action
according to the error codes listed in the table below.
Message
This machine is not supported.
NvRAM access error
Hard disk access error
The system-specific information
does not exist on the baseboard.
Please restore the backup data or
write the data by using [System
Information Management] of the
Off-line Maintenance Utility. Only
the authorized personnel are
allowed to do this operation.
Cause and Remedy
This EXPRESSBUILDER version cannot
be used for this server. Execute the NEC
EXPRESSBUILDER on the compliant
server.
Cannot access to the nonvolatile memory
(NvRAM).
The hard disk is not connected or it is
faulty.
Check whether the hard disk is correctly
connected.
This message is displayed when NEC
EXPRESSBUILDER cannot find device
specific information due to the replacement
of a motherboard, etc.
Maintenance personnel write information
using offline maintenance utility.
Troubleshooting 7-23