Table of Contents
Advertisement
PHY Configuration
The following screen is displayed when "PHY Configuration" is selected in the menu.
See the following table for each item
Item
Parameter
PHY Rate
[Auto]
1.5
3.0
SAS Address
0-F
1.
Press F6 to return to the initial value.
2.
To quit, press Esc until you see the closing message (If any changes have been made, the
massage asking you whether or not to save the changes is displayed.).
3.
When the closing message is displayed, select [Yes] to quit SerialSelect Utility and restart the
system by pressing any key. The changes made in SerialSelect Utility are enabled after the
system is restarted.
Disk Utilities
The following screen is displayed when "Disk Utilities" is selected in the menu.
Description
Data transfer rate between SAS controller and devices. The
initial value is set to [Auto]. SAS card adjusts the rate if
necessary.
Specifies the last digit of a 64-bit SAS address of the SAS
controller, device, and each port using a globally unique
worldwide name (WWN) identifier.
[
]: factory-setting
System Configuration 4-39
Advertisement
Table of Contents
Troubleshooting
