NEC N8800-103F User Manual page 174

5-24 Installing and Using Utilities
LAN Monitoring Report
The LAN monitoring function defines the line status depending on the number of transmission
packets and the number of packet errors within a certain period. Thus, the LAN monitoring function
may report a line fault or high line load only in a temporary high line impedance state. If a normal
state recovery is reported immediately, temporal high line impedance may have occurred thus there
is not any problem.
LAN Monitoring Threshold
Because the NEC Express5800/ft series detects hardware faults on the network in the driver level,
NEC ESMPRO Agent does not monitor line faults. Thus, the value set for "Line fault occurrence
rate" of a [LAN] tab of [NEC ESMPRO Agent properties] in the control panel is not used.
Community Authority
Depending on your OS type or its version, settings for community, SNMP service's security
function, are not made, or default settings of authority are different.
To enable the remote shutdown and threshold change functions via NEC ESMPRO Manager, make
settings of community and set its authority to "READ CREATE" or "READ WRITE."
Hardware Monitoring by ESMPRO
In NEC Express5800/320Fc-MR, an alert report is not issued if an error on temperature/fan/power
supply/voltage is detected in CPU module and PCI module.
Moreover, the trees [Temperature], [Fan], [Voltage], and [Power Supply] are not displayed on
[System Environment] of Data Viewer of NEC ESMPRO Manager.
Change of SNMP Community
If the security setting of the SNMP Service of a system, where the NEC ESMPRO Agent is installed,
is changed from the default "public" to a community name, change the community settings of the
NEC ESMPRO Agent, too.
1.
Double-click the [NEC ESMPRO Agent] icon in [Control Panel].
2.
Select a desired community name from the [SNMP Community] list box in [SNMP
Setting] of the [General] sheet.
The community names to receive SNMP packets from are listed in the [SNMP
Community] list box.
3.
Click [OK] to terminate the operation.