Hardwire Installation - Dimplex BLF50 Owner's Manual

Fireplace Installation

Hardwire Installation

The fireplace is packaged with a
two prong plug installed for plug-
in convenience. Hard wiring the
fireplace is also an option for any
installation.
WARNING: Do not attempt to
wire your own new outlets or
circuits. To reduce the risk of
fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING: Ensure that the
Main On/Off Switch is set to the
Off position (refer to Operation
section) and that the circuit
on which the fireplace is to be
installed has the power cut
off at the service panel until
installation is complete.
Remove the mirror from the
fireplace:
• Lay fireplace on its back.
• Remove two (2) Phillips screws
from each of the two (2) mirror
brackets (Figure 2).
• Remove mirror brackets.
• With one hand keeping
pressure on the mirror, tilt the
Figure 2
Mirror bracket
fireplace upright and slightly
forward to allow the mirror to
fall out of the inside framing.
CAUTION: Mirror is not
tempered. Do not bump
or drop the mirror to avoid
breakage and personal injury.
• Remove mirror from fireplace.
Remove six (6) Phillips
screws that fasten the media
tray and two (2) screws that
fasten the front panel tabs
(Figure 3). Carefully remove both
components.
Remove one (1) Phillips
screw to release the electrical box
Bracket screws
Mirror
9