Dimplex BLF50 Owner's Manual page 11

Fireplace Installation
three (3) Phillips screws which
hold the junction box to the
fireplace chassis (Figure 6).
Pull the junction box and
power cord out the front of the
fireplace.
Replace removed junction box
cover with the supplied hard-wire
cover replacement (Figure 7) and
install using screws removed in
steps 6 and 7.
Figure 7
Leaving a minimum of three
(3) inches (7.6 cm) of slack, route
the power supply through the hole
in the alternate junction box cover
and secure with a wire clamp (not
supplied).
Connect the black wire (live)
from the unit to the black wire
from the power supply using one
of the wire connectors removed in
step 5 (Figure 8).
Figure 8
Black live
wires
White neutral wires
Connect the white wire
(neutral) from the unit to the white
wire from the power supply using
the second wire connector from
step 5 (Figure 8).
Reposition the electrical
box cover over the wires and
connectors and attach to fireplace
chassis using the screw removed
in step 3.
Carefully reinsert mirror into
fireplace and anchor in place
using mirror brackets and screws
removed in step 1.
Refer to Front Glass
Installation section, page 16 for
final installation procedures.
Wires to
controls
11