Installation Instructions - Dimplex Vivente VVT775 Operating Instructions Manual

All manuals and user guides at all-guides.com

Installation Instructions

Step 1: Choosing Installation Type
The Vivente can be configured in 4 different ways:
• Single-sided – Front glass only (see Fig 1a)
• Two-sided Right (see Fig 1b)
• Two-sided Left (see Fig 1c)
• Three-sided (see Fig 1d).
The Vivente is supplied as a Three-sided configuration.
Please follow the steps below to adjust to your desired arrangement.
1. Remove front bottom trim on unit. See Fig. 2
2. On the desired side you wish to cover, remove side glass trim which is held in place by four
screws. Attach side panel in place of the side trim using the same four screws See Fig. 3A & 3B
3. For Front Glass Only setup, repeat Step 2 on the opposite side of product.
4. Assemble the appropriate front Trim to the product. (Three different trims are provided with the
product to facilitate the various setup options.) See Fig. 2
Step 2: Choosing Back Panel
The Vivente comes with two back panels, offering four different finishes.
The product is provided with one back panel in the unit. If you wish to change this to another back
panel design, it is advised to do so before installing the product. It is possible to fit the back panel
after the product has been installed, but it takes significantly longer and should only be done by a
qualified professional.
All panel finishes provided contain a decorative finish, which complements the flame effect. If so
desired, these back panels can be painted with alternative colours.
The plain panel can also be painted or decorated with wallpaper to create a unique panel, please
follow the instructions on your selected paint or wallpaper adhesive, for bonding on top of the painted
MDF panel.
Please take care not to scratch these panels while storing or fitting them.
Fitting Panel – Before Installation (Recommended)
1. Remove side bracket as displayed on Fig. 4
2. The side bracket can be used to take out the back panel. Insert the bottom part of the side bracket
into the Back Panel notch, and slide out the back panel (Fig.5).
3. Place the desired back panel into position and reassemble side bracket using two screws.
4