Dimplex BLF50 Owner's Manual page 13

Fireplace Installation
Figure 9
Key-hole
Permanent
mounting hole
Remove fireplace from wall
and store in a safe place away
from traffic.
Where marked screw
locations do not line up with a wall
stud, insert (screw in) one (1) of
the two (2) supplied wall anchors
(predrill if required). Repeat if
only two (2) screws line up with a
wall stud.
Screw all four (4) supplied #8,
1½ inch (3.8 cm) square head
mounting screws and washers
into the wall and/or wall anchors
leaving ¼ inch (6.5 mm) of
thread.
Align chosen key-holes with
screws and hang fireplace on the
wall. Screw heads and washers
Wall stud
will fit through key-holes and
fireplace will slide down into place
(screws will slide into narrow part
of key-holes).
screws down on fireplace chassis.
square head screws through two
of the permanent mounting holes
which align with a wall stud.
mirror and mirror brackets using
screws from step 1.
Installation section, page 16 for
final installation procedures.
In-wall Recessed
Installation - 2x4 Framing
opening of 46½ inches (118.1 cm)
wide x 16½ inches (42 cm) high
(Figure 10).
supplying power to the unit:
Tighten all four (4) mounting
Screw the two (2) supplied #8
Carefully replace and install
Refer to Front Glass
CAUTION: Two people may
be required for various steps
of this procedure.
Prepare a wall with a framed
Choose your method of
13