Wiring; Hardwire Installation - Dimplex BLF3451 Owner's Manual

Fireplace Installation
the risk of electric shock. This product
is equipped with a cord having an
equipment-grounding conductor and
a grounding plug. The plug must be
plugged into an appropriate outlet
that is properly installed and ground-
ed in accordance with all local codes
and ordinances.
DANGER: Improper connection of
the equipment-grounding conductor
can result in a risk of electric shock.
Check with a qualified electrician or
serviceman if you are in doubt as
to whether the product is properly
grounded. Do not modify the plug
provided with the product – if it will
not fit the outlet, have a proper outlet
installed by a qualified electrician.
This product is for use on a nominal
120-volt circuit and has a grounding
plug that looks like the plug in Figure
1. Make sure that the product is con-
nected to an outlet having the same
configuration as the plug. No adapter
should be used with this product.

Wiring

LINE
8
FLICKER MOTOR
BLOWER MOTOR
NEUTRAL
ELEMENT
ELEMENT
AC/DC ADAPTER
THERMAL
CUTOUT
HTR
RELAY BOARD

Hardwire Installation

The fireplace is provided with a three
prong plug installed for plug-in con-
venience. Hard wiring the fireplace is
also an option for any installation.
WARNING: Do not attempt to wire
your own new outlets or circuits. To
reduce the risk of fire, electric shock
or injury to persons, always use a
licensed electrician.
WARNING:
circuit on which the fireplace is to
be installed has the power cut off
at the service panel until installa-
tion is complete.
1. Carefully remove the electrical
Figure 2
M
SWITCH BOARD
M
DISPLAY / CONTROL BOARD
Ensure that the
LED STRIPS (RGB) - MEDIA
LED STRIPS (RGB) - FLAME
FLAME LED STRIP (AMBER)
THERMISTOR
www.dimplex.com