Dimplex BLF50 Owner's Manual page 17

Fireplace Installation
Carefully mount front glass
assembly so that the front glass
hooks (4) hang on the front glass
mounts on the fireplace (4)
(Figure 16).
Use the supplied two (2)
Phillips sheet metal screws to
fasten the glass assembly tabs to
the fireplace (Figure 17).
Ensure the fireplace's Main
On/Off Switch is switched to the
Off position (refer to operation
section).
If unit is not hard-wired, plug
fireplace into a 15 Amp, 120 Volt
outlet (refer to NOTE 1).
Figure 16
Mounts (4)
Hooks (4)
Figure 17
Tab
17