Front Glass Installation - Dimplex BLF50 Owner's Manual

Fireplace Installation
service panel until installation is
complete.
• Hard wire the fireplace
(recommended). Follow the hard
wiring instructions on page 9.
Lift fireplace and insert
into opening. The fireplace's
mounting trim should be flush
against the wall (Figure 14).
Figure 14
Wall
surface
Mounting hole
Use bubble level (supplied)
to level the fireplace within the
framing. Adjust as required.
Drive four (4) supplied
mounting screws through the four
16
Mounting hole
(4) mounting holes located on
the inside surface of the fireplace
chassis, into wall studs (Figure 14).
Refer to Front Glass
Installation section, page 16 for
final installation procedures.

Front Glass Installation

Evenly distribute supplied
glass rock on the front tray of the
fireplace (Figure 15).
Figure 15
Front glass
assembly
Front tray
www.dimplex.com